Program PIR Sensor dengan Servo Motor menggunakan Arduino Uno di Tinkercad

#include <Servo.h>

// constants won't change
const int PIR_SENSOR_PIN = 7; // Arduino pin connected to motion sensor's pin
const int SERVO_PIN      = 6; // Arduino pin connected to servo motor's pin

Servo servo; // create servo object to control a servo

// variables will change:
int angle = 0;          // the current angle of servo motor
int lastMotionState;    // the previous state of motion sensor
int currentMotionState; // the current state of motion sensor

void setup() {
  Serial.begin(9600);                // initialize serial
  pinMode(PIR_SENSOR_PIN, INPUT); // set arduino pin to input mode
  servo.attach(SERVO_PIN);           // attaches the servo on pin 9 to the servo object

  servo.write(angle);
  currentMotionState = digitalRead(PIR_SENSOR_PIN);
}

void loop() {
  lastMotionState    = currentMotionState;             // save the last state
  currentMotionState = digitalRead(PIR_SENSOR_PIN); // read new state

  if (currentMotionState == LOW && lastMotionState == HIGH) { // pin state change: LOW -> HIGH
    Serial.println("Motion detected!");
    servo.write(90);
  }
  else if (currentMotionState == HIGH && lastMotionState == LOW) { // pin state change: HIGH -> LOW
    Serial.println("Motion stopped!");
    servo.write(0);
  }
}